Gripper for windows instal2/15/2024 The following table shows the specifications with regards to the power supply required to operate the Gripper and the optional Robotiq Controller. Required power supply must match the Robotiq device. This power supply is not included with the Gripper. The Gripper needs to be supplied by a DC voltage source. Emergency stop is not provided, but its use is strongly advised.Fuse (if applicable), see information below.The following parts are required for setup : Optional tools if installing finger kits: AGC-FIN-KIT-085 or AGC-FIN-KIT-140: Metric hex key according to your coupling to mount the coupling onto the robot.4 mm hex key to mount the Gripper onto its coupling. The following tools are required to install the 2-Finger Adaptive Gripper: Please refer to the Spare Parts, Kits and Accessories section. When bought as a kit, the 2-Finger 85 or 140 will come in a package with the appropriate coupling, fingertips or finger pads and cabling.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |